Checking The Network Configuration; Figure 4-1 Advanced Menu - Olympus BIX III User Manual

10-015490-01EN, Rev. 2, June 2020
4.1

Checking the Network Configuration

NOTE
The BTX III can connect to either a wired LAN or broadcast a wireless LAN, but not
both at the same time. The wired LAN connection is the default if an Ethernet cable
and a wireless LAN dongle are both connected to the BTX III at the same time.
To check the network configuration
The default network setting of the BTX III is WIRED ON (Ethernet).
1. Make sure the BTX III is on and the Main menu is displayed.
2. Briefly press both the Left arrow (
same time to display the Advanced menu (see Figure 4-1 on page 50).
3. Press the Down arrow button (
4. Press the Check button (
(Dynamic Host Configuration Protocol) menu (see Figure 4-2 on page 51).
— If the LAN is already set to WIRED ON, the BTX III is configured to connect
to your LAN through the Ethernet connector.
50 Chapter 4
) and Right arrow (
) to select Configure Network.

Figure 4-1 Advanced menu

) to confirm the selection and display the DHCP
) buttons at the