Black & Decker FX400B Original Instructions Manual page 6

ENGLISH
Assembly
1. Wash all detachable parts (see chapter
'Maintenance and cleaning').
2. For the food processor fit the required
accessory blade (U, V, W or X) onto the
blade holder (T). fit the assembled blade
holder into the food processor jug (S)s
3. For the blender fit the jug seal (E)
around the base of the blender blade
(G), place the blade (G) into the blade
holder (F) then place the blade holder
onto the blender jug base (D).
4. Secure the blade holder (F) by turning it
anti clockwise.
Use
1. Place the appliance on a flat, stable
surface.
2. Put the ingredients into the required jug.
3. If using the food processor fit the the lid
(Y) onto the jug (S) by turning it
clockwise.
4. If using the blender push the lid (B) and
filler cap (A) onto the jug (C).
Note: When using the blender or mincer, the
correct lid must be fitted.
5. Place the jug onto the food processor
body (I).
6. Secure the jug by turning it anti
clockwise.
7. Connect it to the electrical supply and
select the required speed using the
rotary switch.
The following settings are available:-
P = Pulse Operation
O = Power Off
1 = Low Speed
2 = High Speed
The appliance should be disconnected from
the mains supply before removing the jug.
6
(Original instructions)
Recommendations when food
processing
Function Types of food
Chopping *1 Vegetables and
fruits
Chopping *1 Meat, cheese
and chocolate
Blending *1 Soups and thick
drinks
Pureeing *1 Cooked
vegetables and
soft fruits
Mixing *1 Pastry and
scones
Mashing *1 Cooked potatoes
and baby food
Kneading *2 Bread dough
Folding in *2 Mousse batter
Creaming *2 Cake batter
Slicing *3 Vegetables and
fruits
Slicing *3 Potatoes and
cheese
Shredding *3 Vegetables and
fruits
Grating *3 Cheese and
chocolate
Whisking *4 Eggs
Whipping *4 Cream
Emulsifying *4 Light batters
for omlettes,
pancakes etc
*1 Use the Chopping blade (W)
*2 Use the kneading blade (V)
*3 Use the grating disc (X)
*4 Use the Emulsifier (U)
Note: The The food processor functions
should not be run for longer than 1 minute.
After a continuous run of 1 minute, the
blender should be allowed to cool down for
at least 2 minutes before further use.
Speed Time
Pulse 15 sec
or 2
1 20 sec
1 20 sec
1 10-15
sec
2 40 sec
2 60 sec
1 20 sec
1 15 sec
1 30 sec
1 or 2 5 sec
1 5 sec
1 or 2 5 sec
1 5 sec
2 1-2 min
2 1-2 min
2 1-2 min