JVC MC-8200LU Service Manual page 9

2.1.6 Removing the Carrier Mechanism
1. Open the door. (Refer to 2.1.2.)
2. Remove the center panel. (Refer to 2.1.5.)
3. Remove the #3 and #4 magazines. (Refer to 2.1.3.)
For the MC-8600U, remove the #3 and #4 magazines in the
same way.
4. Remove the three screws
5. While holding the lower section of the carrier mechanism,
rotate the shaft of the U/D motor by hand to shift the carrier
mechanism to the #3/#4 magazine position.
2-5
3
.
3
6. Remove the carrier mechanism upward.
7. Turn the carrier mechanism upside down, and remove the
4
screws retaining the flat cable mounting bracket.
8. Release the flat cable connector lock and disconnect the flat
cable to remove the carrier mechanism.
Note:
Pay attention not to damage the lock of the flat cable con-
nector .
Bracket
4