JVC MC-8200LU Service Manual page 11

2.1.9 Removing the Exterior Side Panel
1. Remove the rear panel. (Refer to 2.1.8.)
2. Remove the side panel. (Refer to 2.1.7.)
3. Remove the six screws
remove the exterior side panel.
8
3 screws
Note:
When removing the power supply unit, chassis PCB or
SCSI PCB, there is no need to remove the exterior side
panel.
2.1.10 Removing the Power Supply Unit
1. Remove the side panel. (Refer to 2.1.7.)
2. Disconnect the connector cables connected to the power sup-
ply unit.
3. Remove the two screws
4. Slightly loosen the two screws
supply unit by sliding it upward.
2-7
8
(ten screws for MC-8600U), to
8
3 screws
10
9
9
.
0
, and remove the power
2.1.11 Removing the Chassis PCB
1. Remove the rear panel (DH). (Refer to 2.1.8.)
2. Remove the side panel. (Refer to 2.1.7.)
3. Remove the chassis PCB and connector cables from the drive
at the drive side. (Leave the cables connected to the drive
power supply as they are.)
4. Disconnect the connector cables from the chassis PCB.
5. Remove the three screws
6. Slide the chassis PCB toward the left and pull it out from the
right side.
2.1.12 Removing the SCSI PCB
1. Remove the rear panel (DH). (Refer to 2.1.8.)
2. Disconnect the two connector cables and all the SCSI ca-
bles connected to the SCSI PCB and the drives.
Connector cable
!
.
11
12