JVC MC-8200LU Service Manual page 10

2.1.7 Removing the Side Panel
<MC-8200U>
1. Remove the eight screws
When removing the side panel, unscrew while holding the
side panel with your hands. (To prevent the panel from drop-
ping.)
<MC-8600U>
6
1. Remove the 16 screws
When removing the side panel, unscrew while holding the
side panel by hand. Pay special attention to the upper side
panel. (in order to prevent the panel from being dropped.)
6
6
Note:
When removing the U/D motor and magazine sensor PCB,
remove the upper side panel.
6
to remove the side panel.
6
to remove the side panels.
2.1.8 Removing the Rear Panel
<MC-8200U>
1. Remove the three rear panels (T), (DH) and (B) by removing
7
the four screws for each.
<MC-8600U>
1. In the same way as MC-8200U, remove the two rear panels
(DH) and (B).
2. Remove the eight screws
(T6).
Note:
When removing the power supply unit, chassis PCB or
SCSI PCB, you don't have to remove the rear panels.
(T)
7
4 screws
(DH)
7
4 screws
(B)
7
4 screws
7
to remove the upper rear panel
(T6)
7
8 screws
2-6