JVC MC-8200LU Service Manual page 12

@
3. Remove the screw and pull the SCSI PCB toward you
until the connector at the right sides are exposed, then dis-
connect the two connectors from the chassis side.
4. Remove the SCSI PCB by pulling it toward you.
5. When mounting the SCSI PCB, insert it so that the PCB
bracket passes under the guide rails.
Bracket Connector cable
2.1.13 Removing the Mail Slot
1. Open the door. (Refer to 1.1.2.)
2. Remove the side panel. (Refer to 1.1.7.)
3. Remove the #2 magazine. (Refer to 1.1.3.)
4. Insert your hand into the #2 slot and gently push the tray of
the mail slot. Pay attention not to push the tray forcibly for it
could damage the gear teeth.
5. Gently pull out the mail slot tray toward you and push the
guide to the main unit side. Remove the screws
out the mail slot panel by sliding it toward the left.
Guide
13
6. Remove the eight screws
7. Disconnect the connector cable on the mail CN PCB, and
8. Remove the mail slot from the front of the main unit.
#
and pull
Mail slot panel
$
the main unit.
14
%
remove the two screws .
to remove the front panel of
14
15
Connector cable
2-8