Roof Assembly - Arrow Storage Products ED106 Owner's Manual & Assembly Instructions

Step 15
X28
1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
2
Cut 2 short 2" (5,1 cm) strips o
the roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape.
Unroll the tape and press it down over
the opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
3
Install 4 roof panels in the se-
quence and positions shown on
previous page. Do not fasten the
lower end of the panels to the side
wall angles at this time. Continue
weather stripping the ridge opening.
Fasten roof panel overlaps not used
for ridge cap (roof center). Cover the
head of bolt with 2" (5,1 cm) piece of
weather stripping tape.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
Parts Needed For

Roof Assembly

STEP
1
8468 Right
Roof Panel
Screws To Roof Beam
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
Do not fasten
at this time
Cut Weather
Stripping and
Fold Under.
28
8468 Right Roof Panel (1)
8469 Left Roof Panel (2)
6529 Roof Panel (4)
8469 Left Roof Panel
Fasten At
Overlap with
Bolt
STEP
Weather Stripping
2
Tape Roll
6529 Roof Panel
STEP
3
Strips