Registering A Dtmf Code - Yaesu FTM-3200DE Advance Manual

Registering a DTMF code

1. Press and hold in the [ MHz ( SETUP )] key for
one second to enter the Set mode.
2. Rotate the DIAL knob to select "DT SET 16".
3. Press the [ MHz ( SETUP )] key momentarily,
then rotate the DIAL knob to select the de-
sired memory channel (C0 to C9) to register
the DTMF code.
4. Press the [ D/A ( GM )] key momentarily, then
rotate the DIAL knob to select the first digit
of the DTMF code.
Note: You can also use the keypad on the
microphone to input the DTMF code.
5. When you have selected the correct digit,
press the [ V/M ( MW )] key momentarily. Now,
rotate the DIAL knob to select the second of
16 available numbers in the current DTMF
Autodialer memory register.
6. Repeat this procedure for each digit in the DTMF code.
Note: m To make a correction, press the [ SQL ( TXPO )] key to back-space the cursor,
then re-enter the correct number.
m Press and hold in the [ REV ( DW )] key for one second to delete all data after
the cursor that may have been previously stored.
7. When entry of all digits is complete, press and hold in the [ MHz ( SETUP )] key for one
second to set the DTMF code and exit to normal operation.
FTM-3200DR/DE Advance Manual
Advanced Operation
VOL
SQL REV D/A M H z V / M
TXPO D W M W
SETUP
DIAL
11