Table of Contents
Advertisement
7.4 Commissioning Sheet
Installer; please complete all sections of this form.
SYSTEM INFORMATION
ICE MODEL
(Outdoor Unit)
ICE MODEL
(Indoor Unit)
HEATER MODEL
INSTALLED BY/ DATE
PRE START-UP (Please tick boxes below as each item is completed).
VERIFY THAT ALL PACKAGING MATERIALS HAVE BEEN REMOVED FROM UNIT.
REMOVE ALL SHIPPING HOLDDOWN BOLTS AND BRACKETS, AS PER INSTALLATION INSTRUCTIONS.
CHECK THAT CONDENSATE CONNECTION IS INSTALLED, AS PER INSTALLATION INSTRUCTIONS.
CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS.
CHECK THAT INDOOR RETURN AIR FILTER IS CLEAN AND IN PLACE.
VERIFY THAT UNIT INSTALLATION IS LEVEL.
CHECK FANS FOR ALIGNMENT AND NOISE.
OPERATION CHARACTERISTICS
(Please record the following data after at least 20 minutes running time).
Suction Pressure
Suction Line Temperature
Discharge Pressure
Liquid Line Temperature
Superheat
Sub-cooling
Compressor Amps (L1)
Indoor coil Air On (Return) Temperature
Indoor coil Air Off (Supply) Temperature
Outdoor air Temperature (Ambient)
Length of liquid line
Length of suction line
Liquid line Diameter
Suction line Diameter
Extra refrigerant quantity charged (if any)
Supply voltage
Actual voltage
SERIAL No.
(Outdoor Unit)
SERIAL No.
(Indoor Unit)
HEATER SERIAL No.
27
kPa
o
C
kPa
C
o
K
K
A
C DB
o
C DB
o
o
C DB
m
m
mm
mm
kg
V
V
Advertisement
Table of Contents
