10. Repair Instructions Wall Saw; 10.1. Blade Gard; Replacing The Bearings In The Blade Guard Guide Wheels; Disassembly - Husqvarna WS440HF Workshop Manual

10.1

10. REPAIR INSTRUCTIONS WALL SAW

1
3
5
1
3
72
REPAIR INSTRUCTIONS
2
4
2
4

10.1. BLADE GARD

Replacing the Bearings in
the Blade Guard Guide
Wheels

Disassembly

1� The arrows indicate the adjustable
guide wheels�
2� To remove the adjustable wheels,
remove the nut and axel using a
wrench on each side�
3� To remove non-adjustable guide
wheels, use a wrench�
4� Remove circlip using a pliers�
5� Use a press or a pin punch
and rubber club to remove the
bearing�

Assembly

1� Press the new bearing into place�
2� Put the circlip back into position
using a circlip pliers�
3� For the adjustable wheels, put
the spacer, nut and wheel into
position and tighten the hex screw
on the back� Use a wrench on the
front�
4� For non-adjustable wheels, put
the spacer, nut and wheel into
position and tighten the screw
with a wrench� Check that the
wheels spin easily by hand�
Remember to calibrate the two
adjustable wheels after repair.