Assemble The Feed Shaft; Click For 3D Steps - Husqvarna WS440HF Workshop Manual

10.3
1
3
5
7
9
1 1 8
REPAIR INSTRUCTIONS
2
4
6
8

Assemble the Feed Shaft

Click
for 3D
steps
First see: Remove Feed Motor
Gearbox (p. 102)
1� Apply grease and fit a new o-ring.
2� Place the shaft on a spacer�
Suggested the old bearing�
3� Mount the arm carrier ring�
4� Place the set of 2 washers and
bearing on the shaft�
5� Place the slip clutch and another
set of washers and bearing on the
shaft�
6� Apply grease to a new o-ring and
thread it on the shaft�
7� Lubricate properly all over the gear
wheels, the bearing and o-rings�
8� Apply heat to the housing�
Attention! The housing is hot.
9� Insert the complete shaft into the
housing�