Hardware Setup - Texas Instruments BOOSTXL-DRV8323Rx User Manual

www.ti.com
If the automatic driver installation fails for some reason, or if the Don't Install button was clicked, install the
drivers manually. First find the driver .inf file (msp430_ti_signed.inf) in the following folder: C:\Program
Files (x86)\Texas Instruments\BOOSTXL-DRV832X\TI MSP430 USB Driver. Right click on the .inf file and
select the Install option. Follow the installation instructions to successfully install the driver.
If any issues occur during the driver installation steps or to learn more about the process, download and
extract the MSP430 USB Developers Package from
sections 2.5.2 for Windows 7 and 2.5.3 for Windows 8 in the document
Examples_Guide_MSP430_USB.pdf based on the appropriate Windows. This document can be found
under the MSP430USBDevelopersPackage_5_10_00_17\MSP430_USB_Software\Documentation
directory of the extracted MSP430 USB Developers Package.
4.2

Hardware Setup

The hardware required to run the motor control is an MSP430F5529 LaunchPad development kit, the
BOOSTXL-DRV8323Rx BoosterPack plug-in module, a Micro-USB cable, and a power supply with a DC
output from 8 to 54 V. Follow these steps to start up the BoosterPack plug-in module:
Step 1. Dock the BOOSTXL-DRV8323Rx BoosterPack plug-in module to the MSP430F5529
LaunchPad development kit through the two 40-pin headers J3 and J4.
NOTE: Observe the correct polarity of the 40-pin LaunchPad headers. The MSP430F5529
LaunchPad header J1 should be connected to BOOSTXL-DRV8323Rx BoosterPack header
J3 and MSP430F5529 LaunchPad header J2 should be connected to BOOSTXL-
DRV8323Rx BoosterPack header J4.
Step 2. Connect the three phases from the brushless DC motor to the J5 connector on the
BOOSTXL-DRV8323Rx BoosterPack plug-in module. Phase A, B, and C are labeled in white
silkscreen on the PCB top layer.
NOTE: If using the sensored firmware on the MSP430F5529 LaunchPad development kit, connect a
brushless DC motor Hall sensor inputs to header J2. If using sensorless firmware header J2
can be left unconnected.
NOTE: If using 1x PWM Mode with the sensored firmware R36, R37, and R38 must be populated
with 0-Ω resistors.
Step 3. Connect the DC power supply to header J1.
NOTE: Observe the correct polarity of +VM and GND connections on the BOOSTXL-DRV8323Rx
BoosterPack connection J1
Step 4. Connect a Micro-USB cable to the LaunchPad development kit and computer.
Step 5. Turn on the power supply and power up the PCB.
SLVUB01C – February 2017 – Revised March 2018
Submit Documentation Feedback
Figure 32. TI MSP430 USB Installer
www.ti.com/tool/msp430usbdevpack
Copyright © 2017–2018, Texas Instruments Incorporated
and refer to
BOOSTXL-DRV8323Rx EVM User's Guide
GUI Application
21