Table of Contents
Advertisement
www.ti.com
3.4
Updating the MSP430 USB-FET
After the reference project is imported and selected in the CCS software, the provided software builds and
runs on the MSP430 device. The device is programmed by the MSP430 USB-FET. When this device is
used, the CCS software automatically detects the firmware version and notifies of an update. The process
takes a few minutes, let the update complete before unplugging the USB cable or closing CCS.
and
Figure 31
show the update process.
To help prevent any device damage, wait for the update to finish before
unplugging the MSP430 device or closing CCS.
SLVUB01C – February 2017 – Revised March 2018
Submit Documentation Feedback
Figure 29. New CCS Project
CAUTION
Copyright © 2017–2018, Texas Instruments Incorporated
Firmware Installation
BOOSTXL-DRV8323Rx EVM User's Guide
Figure 30
19
Advertisement
Table of Contents
