Dimplex DCSS12 Instruction Manual page 13

OPERATING INSTRUCTIONS
COOLING MODE
The cooling function allows the air condit-
COOL
ioner to cool the room and at the same time
reduces Air humidity.
To activate the cooling function ( COOL ) , press the
MODE button until the symbol
appears on the display.
The cooling function is activated by setting the button
or at a temperature lower than that of the room.
To optimize the function of the Air conditioner, adjust
the temperature (1) , the speed (2) and the direction
of the air flow (3) by pressing the button indicated.
HEATING MODE
The heating function allows the air conditi-
HEAT
oner to heat the room.
To activate the heating function ( HEAT ) , press the
MODE button until the symbol
appears on the display.
With the button or
that of the room..
To optimize the function of the Air conditioner adjust
the temperature ( 1 ), the speed ( 2 ) and the direction
of the air flow ( 3 ) by pressing the button indicated
If the appliance is fitted with a electrical heater,
which delays appliance to startup in a few seconds
to ensure an immediate output of hot air (Optional ,
depends on the model).
In HEATING operation, the appliance can automatically
activate a defrost cycle, which is essential to clean the
frost on the condenser so as to recover its heat exchange
function.This procedure usually lasts for 2-10 minutes
during defrosting,indoor unit fan stop operation.
After defrosting ,it resumes to HEATING mode
automatically.
( COOL
( HEAT
set a temperature higher than
)
)
11
COOL
HEAT