Perkins 403J-E17T Operation And Maintenance Manual page 42

42
Operation Section
Monitoring System
" " Shutdown" "
The orange warning will be "Flashing" . After the
warning, the engine power will be derated. The
engine will continue at the rpm of the set derate until
a shutdown of the engine occurs. After shutdown the
red stop lamp will illuminate.
A shutdown of the engine after being triggered is
immediate. The engine can be restarted after a
shutdown for use in an emergency. However, the
cause of the initial shutdown may still exist.
If there is a signal for high coolant temperature, there
will be a 2 second delay to verify the condition.
If there is a signal for low oil pressure, there will be a
2 second delay to verify the condition.
For more information or assistance for repairs,
consult your Perkins distributor.
Monitoring System
(Engine Warning Indicators)
Table 3
Shutdown
Warning Indicator
Indicator
ON ON
OFF OFF
ON (Solid) OFF
Flashing OFF
i07426635
Table for Warning Indicators
Description of the
Indicator State Indication
Indicator Check Keyswitch in the ON posi-
tion all Indicators should il-
luminate for 0.5 of a
second.
-
No Fault
Level 1
Level 1 An active diagnostic code
is present.
Level 2
Level 2 The ECM has detected an
abnormal condition.
Engine Status Operator Action
Power ON, Indicator If any of the Indicators will
check not illuminate during the
Engine is not Indicator check, the fault
operating. must be investigated
immediately.
If any Indicator stays illu-
minated or flash, the fault
must be investigated
immediately.
Engine operating None
normally.
The engine is operat- As soon as possible the
ing, but one or more diagnostic code should be
diagnostic codes are investigated.
present.
If enabled, the engine Stop the engine.
will be derated. Investigate the fault.
M0094137-02
(continued)