Table of Contents
Advertisement
FRAMING SPECIFICATIONS
Framing Dimensions
Opening
VRT3536 Series
A
42-1/4" (1073)
B
44-1/4" (1124)
C
23-5/8" (600)
D
11-1/4" (286)
E
63-1/2" (1613)
F
31-3/4" (807)
G*
20-1/2" ( 521)
H
44-1/4" (1124)
Table 1 -
This Table corresponds to Figures 8, 9 and 10
* Back wall of chase/enclosure including finishing materials, if any.
WARNING: Do not fill
spaces around the
firebox with insulation
or other materials.
This Figure corresponds
to Table 1
Figure 8
Hood Kit Installation
(see ordering information on Page 16)
The firebox canopy (hood) must not be modified or replaced with a
canopy that may be provided with the unvented decorative room
heater.
NOTE: This hood is optional. See Figure 12.
These hood kits are design to be fitted to the face of the appliance directly
above the firebox opening. In addition to providing an aesthetically pleasing
appearance to your appliance, the hood reduces heat effects to decora-
tive mantels and finish materials located directly above the fireplace and
reduces the Mantel / Trim clearances (see Figures 4 and 5 on Page 7).
Please read this entire manual and understood thoroughly before proceeding
with the installation of these kits.
Step 1. Using a 5/16" nut driver or socket, remove the screen and rod
assemblies as shown in Figure 11.
Step 2. Align the hood with the holes in the side frames as shown in
Figure 12. Install three screws as shown in Figure 12. Make
sure hood is level and secure.
Step 3. Reinstall screen and rod assemblies (see Figure 11).
VRT3542 Series
48-1/4" (1226)
44-1/4" (1124)
29-5/8" (753)
14-1/4" (362)
69-1/2" (1765)
34-3/4" (883)
20-1/2" ( 521)
49-1/8" (1248)
Header
B
A
NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.
Corner Installation
This Figure corresponds to Table 1
H
Figure 9
Parallel Installation
Rough Framing Face
(Unfinished Shown)
Figure 10
Removing Screens & Rods:
Remove screws (see dotted
lines).
Pull out rods from
locating holes on side of firebox
opening.
Reinstalling Screens & Rods:
Insert rods into corresponding
locating holes on sides of firebox
opening, then reinstall screws
as shown.
Figure 11
Back Wall Of Chase/Enclosure
Including Finishing Materials If Any
D
C
A
E
Rough Framing Face
(Unfinished Shown)
Rough Framing Face
(Unfinished Shown)
Back Wall Of Chase/Enclosure
Including Finishing Materials If Any
C
G
A
This Figure cor-
responds to Table 1
F
G
11
Advertisement
Table of Contents
