Exmark ULTRAVAC BAGGER 126-6954 Operator's Manual page 12

For ultravac serial nos. 402,082,300 & higher
Hide thumbs Also See for ULTRAVAC BAGGER 126-6954:
Table of Contents

Advertisement

Operation
5.
Pull the idler release handle and remove the belt
from the upper groove of the deck sheave.
6.
Unlatch the front end of the blower. Pivot the
blower back and lift it off the deck.
1. Blower latch
2. Pivot blower away from deck
7.
Install the discharge deflector using the chute
pivot pin and hairpin (see Figure 7).
1. Hairpin
2. Chute pivot pin
WARNING
An uncovered discharge opening will
allow objects to be thrown in operator's or
bystander's direction. Also, contact with
blade could occur. Thrown objects or blade
contact can cause serious injury or kill you
or bystanders.
Never operate mower unless discharge
deflector, or entire grass collection system, or
mulch kit is installed.
Figure 6
Figure 7
3. Discharge deflector
8.
Re-install the plastic belt cover and tighten the
knobs.
9.
Remove the bags from the hopper assembly by
opening the hopper and lifting up on the rear of
the bag and then unhooking the front clip.
10.
Remove the hopper assembly.
A.
Push and hold the hopper assembly towards
the unit and pull the hairpins and mount pins
from frame mount barrel located on each side
of the frame legs.
WARNING
When the mount pins have been removed,
the hopper assembly may fall. A falling
hopper assembly may cause injury.
g037112
Use care when the mount pins are
removed and if necessary, use assistance
when lowering the hopper assembly to the
ground.
B.
If necessary, use assistance and carefully lower
the hopper assembly to the ground.
C.
Re-insert the mount pins into the frame
mount barrel and secure with the hairpin.
11.
Pull out both ROPS pins that are located below
the ROPS pivot.
12.
The removable weights must be removed from
the unit.
Remove the caster weights by loosening the
g009319
clamping knobs until the bolt can be rotated away
from the caster arm. Carefully lift the weights off
the caster arms.
Note: The removable weights are heavy. Use
care when lifting them. Make sure that you can
hold them securely before lifting them. Use
caution when positioning your hands so that you
Do Not set them down on your hands or fingers.
12

Advertisement

Table of Contents
loading

Table of Contents