Framing And Finishing - Regency Panorama PG33NG4-R Owners & Installation Manual

installation
Rear Termination
Simpson Dura-Flue Piping
Flex Piping
For Both Simpson & Flex
NOTE: If this is an outside corner, the minimum
distance between the flue and the outside corner
is 6" (15cm) with AstroCap termination cap or 12"
(30cm) with Dura-Flue termination cap.
Vertical Termination or
Vertical Rise with Horizontal
Termination
For Both Simpson & Flex
8

FRAMING AND FINISHING

Simpson Dura-Flue
Minimum Clearances
Top Header
1/2"
(13mm)
wall for Dura-Vent
Drywall
1-1/2"
(38mm)
4"
3"
(102mm) (76mm)
Opening for gas
connection
Flex Pipe
Minimum Clearances
Top Header
1/2"
(13mm)
Drywall
1-1/2"
(38mm)
4" 3"
(102mm) (76mm)
Opening for gas
connection
NOTE: If this is an outside corner, the minimum
distance between the flue and the outside corner
is 6" (15cm) with AstroCap termination cap or
12" (30cm) with Dura-Flue termination cap.
1) Determine the total thickness of facing mate-
Install Side Nailing Strips, and Top Facing
10" (254mm)
Support before unit is slipped into position.
dia. Hole through
See page 9 for assembly details.
2) Frame in the enclosure for the unit with
3) For exterior walls, insulate the enclosure to
16-1/2"
4) The top of the unit must not be closer than
(419mm)
Minimum
5) Combustible material may be brought up to
Note: The unit does not have to be complete-
10" (254mm)
dia. Hole through
wall for Flex
6) Use steel studs for framing where the
12-3/4"
(324mm)
Minimum
rial (e.g. drywall plus ceramic tiles) to allow
the finished surface to be flush with the front
of the unit. Total facing thickness can vary
from 1/2" (13mm) to 1-1/4" (32mm) thick.
framing material.
the same degree as the rest of the house,
apply vapour barrier and drywall, as per lo-
cal installation codes. (Do not insulate the
fireplace itself.)
30" (762mm) to the ceiling.
the top and sides of the unit and be covered
with ceramic tiles, bricks, rock or other suit-
able combustible finishing materials.
ly enclosed in a chase. The clearance
on top of the unit is 0" to the standoffs
so combustible building materials can
be laid directly on top of the standoffs.
You must maintain clearance from the
flue to combustible materials for flex
for Simpson Dura-Flue, see page 7.
1-1/2" (38mm) clearance from the flue to
combustible material cannot be maintained.
Regency PG33NG4-R Gas Inbuilt