Table of Contents
Advertisement
Change the drain hose position
Rear view for left piping installation
Drain cap
•
How to pull the piping and drain hose out,
in case of the embedded piping.
Apply putty or caulking
material to seal the wall
opening.
PVC tube for
drain hose (VP-20)
12.2.4
Connect the Cable to the Indoor Unit
1
The inside and outside connection cable can be connected without removing the front grille.
2
Connection cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed
4 x 1.5 mm
2
flexible cord, type designation 60245 IEC 57 or heavier cord. Do not use joint connection cable.
Replace the wire if the existing wire (from concealed wiring, or otherwise) is too short. Allowable connection
cable length of each indoor unit shall be 30 mm or less.
3
Bind all the indoor and outdoor connection cable with tape and route the connection cable via the left side
escapement.
4
Remove the tapes and connect the connection cable between indoor unit and outdoor unit according to the
diagram below.
5
Secure firmly the connection cable onto the control board with the holder.
Do not overtighten holder screw, as this may damage the holder.
Drain hose
Connection
cable
Piping
Drain hose
from main unit
PVC tube (VP-65) for piping
and connection cable
PVC tube for drain hose (VP-30)
PVC tube for
drain hose
Indoor unit
55 mm
Terminals on the indoor unit
Colour of wires
Terminals on the outdoor unit
Piping
Sleeve for piping hole
Drain hose
•
In case of left piping how to insert the
connection cable and drain hose.
Drain hose
Cable
Piping
(For the right piping, follow the same procedure)
1
2
3
1
2
3
30
Connection cable
More than 950 mm
Cable
Piping
Hide quick links:
Advertisement
Table of Contents
