Payne C Series Installation, Start-Up, Operating And Service And Maintenance Instructions page 27

PERFORATED
DISCHARGE DUCT
FLANGE
SCREWS (2)
Representative drawing only,
some models may vary in appearance.
1 Lay furnace on the back or side
2 Remove the two (2) screws that secure the bottom
closure panel to the furnace casing and remove the
panel
Fig. 23 − Removing Bottom Closure Panel (2 Screws)
UPFLOW
90°
YES
YES
120°
MIN
NO
Fig. 22 − Duct Flanges
BOTTOM
CLOSURE
1
2
A170123
3
4
27
DOWNFLOW
YES
YES
120°
MIN
NO
SCREWS (4)
BOTTOM
PLATE
Representative drawing only,
some models may vary in appearance.
Lay furnace on the back or side
Remove the four (4) screws that secure the bottom
plate to the furnace casing
Remove the bottom closure from the casing
Re−install the bottom plate to the furnace casing and
re−install the four (4) screws
Fig. 24 − Removing Bottom Closure Panel (4 Screws)
HORIZONTAL
90°
YES
YES
120°
MIN
NO
A10493
A170124