Table of Contents
Advertisement
Customizing Features / Options
SALT EFFICIENCY
When this feature is ON, the water softener will
operate at salt efficiencies of 4000 grains of hardness
per pound of salt or higher (May recharge more often
using smaller salt dosage and less water). The
softener is shipped with this feature set OFF.
1. Press and hold the PROGRAM button until one of
the screens in Figure 23 is displayed. Once in this
display, press the PROGRAM button once, and
one of the two displays in Figure 24 is shown.
s
2. Press the
UP or
OFF. When set to ON, the efficiency icon will be
displayed in the upper right hand corner of the
normal run display.
3. Press the PROGRAM button three times to return
to the normal run display (See Figure 25).
Displayed when efficiency
is set to "ON"
In the state of California: You must turn the Salt
Efficiency Fea ture ON. This may initiate more
frequent recharges. However, it will operate at
4,000 grains per pound of salt or higher.
FIG. 23
DOWN buttons to set ON or
FIG. 24
Efficiency Icon
FIG. 25
MAXIMUM DAYS BETWEEN REGENERA-
TIONS
The water softener automatically controls regeneration
frequency. This provides the greatest operating
efficiency and, under most conditions, this feature
should be left in this automatic mode. However, you
may modify this feature if you want to force a
regeneration every set number of days. For example,
if your water supply contains clear water iron, you
may want the softener to regenerate every few days
to keep the resin bed clean. The maximum days
between recharges may be set from 1 to 15 days, as
follows:
NOTE: The softener will recharge on its own if need-
ed, even if it is before the set number of days.
1. Press and hold the PROGRAM button until the
screen in Figure 23 is displayed. Once in this
display, press the PROGRAM button two times,
and the display in Figure 26 is shown.
2. Press the
UP or
number of days.
3. Press the PROGRAM button twice to return to the
normal time of day screen.
12 OR 24 HOUR CLOCK
At the default setting, all clock displays are shown in
12 hour time format (AM and PM). If 24 hour time
format is desired, follow the steps below:
1. Press and hold the PROGRAM button until the
screen in Figure 23 is displayed. Once in this
display, press the PROGRAM button three times
and one of the two displays in Figure 27 is shown.
2. Press the
UP or
time format.
3. Press the PROGRAM button once again, to return
to the normal time of day screen.
14
FIG. 26
s
DOWN buttons to set the
FIG. 27
s
DOWN buttons to set the
Advertisement
Table of Contents
