Table of Contents
Advertisement
Programming the Water Softener
Display
RECHARGE
button
CLEAN REMINDER
The screen in Figure 17 appears, with "CLEAn" flash-
ing in the display, when four months have elapsed on
the system's timer since start up or the last reset.
This is a reminder to use Whirlpool
Water Softener Cleanser three times a year. To reset
the timer, press any button on the control panel and
"CLEAn" will disappear.
PROGRAM THE SOFTENER
When the power supply is plugged into the electrical
outlet, the model code (Lt30) and a software version
number (example: J3.9), are briefly shown in the
display. Then the words "PRESENT TIME" appear
and 12:00 PM begins to flash.
Questions? Call Toll Free 1-866-986-3223
When you call, please be prepared to provide the model and serial number,
found on the rating decal, typically located on the rim below the salt lid.
FIG. 17
WHE-WSC
®
12
SET TIME OF DAY
If the words "PRESENT TIME" do not show in the
display, press the PROGRAM button until they do.
s
1. Press the
UP or
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
NOTE: Press buttons and quickly release to slowly
advance the display. Hold the buttons down
for fast advance.
SET WATER HARDNESS NUMBER
1. Press the PROGRAM button once again to display
a flashing "25" and the word "HARDNESS".
s
2. Press the
UP or
water's hardness number.
whirlpoolwatersolutions.com
or visit
UP button
DOWN
button
PROGRAM
button
FIG. 16
DOWN buttons to set the
FIG. 18
FIG. 19
DOWN buttons to set your
Advertisement
Table of Contents
