Adjusting The Caller Level; Adjusting The Microphone Level; Adjusting The Ring Tone Level; Key Sound Volume Setting - Alpine OWNER'S MANUAL Owner's Manual

Adjusting the Caller Level

You can adjust the volume of the incoming call.
Setting item:
Caller Level
Setting contents:
1 to 35 (Initial setting: 10)

Adjusting the Microphone Level

You can adjust the transmit volume, during the call.
Setting item:
Microphone Level
Setting contents:
1 to 11 (Initial setting: 5)

Adjusting the Ring Tone Level

You can adjust the receive volume, during the call.
Setting item:
Ring Tone Level
Setting contents:
1 to 6 (Initial setting: 3)

Key Sound Volume Setting

You can change the volume of the sound heard when a button is
touched.
Setting item:
Key Sound
Setting contents:
0 to 6 (Initial setting: 3)

Auto Volume Setting

The volume of the sound heard is raised automatically according to the
noise level by detecting engine noise and road noise.
Setting item:
Auto Volume
Setting contents:
Off (Initial setting) / Low / Middle / High
• The increasing rate of volume becomes large in this order: Low
Middle High.

Setting Audio Mute On/Off while Backing up

The sound can be muted when the shift gear lever is set to the reverse
(R) position enabling you to easily hear sensors, etc., while reversing
your car.
Setting item:
Mute while backing up
Setting contents:
Off / On (Initial setting)
Off: Does not mute.
On: Mutes when the shift gear lever is set to the reverse (R)
position.

Setting the Microphone Effect

Set this item when Apple CarPlay is used/Android smartphone which
installed Android Auto App is connected.
You can turn on or off the Microphone Effect.
This setting influences Apple CarPlay/Android Auto mode.
Setting item:
Microphone EC / NR
Setting contents:
On (Initial setting) / Off

Default Sound Settings

You can restore the Dual HD EQ*/X-OVER*/Time Correction*/MX HD
Level/Rear Speaker/Subwoofer/Subwoofer Level/Subwoofer Phase to
factory settings.
Setting item:
Default Sound Settings
Touch [Set], and the confirmation message appears.
To initialise, touch [OK].
* The setting values that are stored in Preset 1 to Preset 3 cannot be
initialised.
31