Battery Charging Instructions - Terex Genie IWP Super Series Operator's Manual

Sixth Edition • First Printing
Batter y Charging Instr ucti ons
Battery and Charger Instructions
Observe and Obey:

Do not use an external charger or booster
battery.

Charge the battery in a well-ventilated area.

Use proper AC input voltage for charging as
indicated on the charger.

Use only a Genie authorized battery and
charger.
To Charge Primary Battery
1 Open the battery pack lid to access the
battery.
2 Remove the battery vent caps and check the
battery acid level. If necessary, add only
enough distilled water to cover the plates. Do
not overfill prior to the charge cycle.
3 Replace the battery vent caps.
4 Be sure that the DC output cord is properly
connected to the battery. Black to negative,
red to positive.
5 Connect the battery charger to a grounded AC
circuit.
6 The charger will turn off automatically when
the battery is fully charged.
7 Check the battery acid level when the charge
cycle is complete. Replenish with distilled
water to the bottom of the fill tube. Do not
overfill.
Part No. 1298036GT

Battery Charging Instructions

To Charge Secondary Battery (if
equipped)
1 Disconnect the primary battery from the
machine by unplugging the Anderson
connector located at the rear of the primary
battery box.
2 If the primary battery was already
disconnected, ensure that the secondary
battery is not connected to the machine.
3 Remove the battery vent caps and check the
battery acid level. If necessary, add only
enough distilled water to cover the plates. Do
not overfill prior to the charge cycle.
4 Replace the battery vent caps.
5 Connect the Anderson connector from the
secondary battery to the Anderson connector
located at the rear of the primary battery box.
6 Connect the battery charger contained in the
top of the primary battery box to a grounded
AC circuit.
7 The charger will turn off automatically when
the battery is fully charged. If both batteries
are discharged, it could take up to 24 hours to
completely charge both batteries.
8 Check the battery acid level when the charge
cycle is complete. Replenish with distilled
water to the bottom of the fill tube. Do not
overfill.
®
IWP Super Series
Operator's Manual
37