Water inlet fault
Problem
The Inlet/Drain indic-
ator flashes on and off.
The dishwasher stops
during a programme.
The Inlet/Drain indic-
ator flashes.
Fault code or ap-
pears in the display.
Water drainage fault
Problem
The dishwasher stops
during a programme.
The Inlet/Drain indic-
ator flashes.
Fault code shows in
the display.
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 50
kPa (0.5 bar).
Seek professional advice.
Cause and remedy
Before rectifying the problem:
Switch the dishwasher off with the button.
The water outlet is restricted.
There might be water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care, Cleaning the filters").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kink or loop in the drain hose.
Problem solving guide
69