Lennox LI012CO-230P432 Service Manual page 106

Service Manual
Steps
9.Remove motor support
Twist off the tapping screws fixingthe motor
support, pull it upwardsand then remove the
motor support.
10.Remove isolation sheet
Twist off the screws connecting isolation sheet
and end plate of condenser and chassis, and
then remove the isolation sheet.
11.Remove 4-way valve
Unsolder the pipeline between compressor,
condenser, gas and liquid valve, and then
remove the 4-way valve. (note: release all
refrigerant before unsoldering).
Installation and Maintenance
Procedure
motor support
isolation sheet
4-way valve
103