Speedometer; Odometer/Trip Meter - Subaru 2008 Impreza Owner's Manual

3-12
Instruments and controls
*: " " or " " cannot be displayed when
the ignition switch is in the "ON" posi-
tion.
To change the current setting, press the
trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
Your vehicle's initial movement
setting of the meter/gauge needles
has been set for activation "
time of shipment from the factory.
It is not possible to cancel the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the "ON" position. Cancel the setting
when the ignition switch is in the
"LOCK" or "Acc" position.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer/Trip meter
1) Trip knob
This meter displays the odometer and two
trip meters when the ignition switch is in
" at the
the "LOCK", "Acc" or "ON" position.
If you press the trip knob when the ignition
switch is in the "LOCK" position, the
odometer/trip meter will light up. It is
possible to switch the indications while
the odometer/trip meter is lit up. If you do
not press the trip knob within 10 seconds
of illumination of the odometer/trip meter,
the odometer/trip meter will go off.
The display can be switched as shown
below by pressing the trip knob.
*: " " or " " cannot be displayed when
the ignition switch is in the "ON" posi-
tion.
For the " " or " " indication, refer to
"Canceling the function for meter/gauge
needle movement upon turning on the
ignition switch" in this section.