Subaru 2002 Forester Owner's Manual page 45

4. To make the lap part tight, pull up on the shoulder belt. And place
the lap belt as low as possible on your hips, not on your waist.
n Adjusting the rear seat shoulder belt anchor height
WARNING
When wearing the seatbelts, make sure the shoulder portion of
the webbing does not pass over your neck. If it does, adjust the
seatbelt anchor to a lower position. Placing the shoulder belt
over the neck may result in neck injury during sudden braking or
in a collision.
The shoulder belt anchor height should be adjusted to the position
best suited for you. To adjust the shoulder belt anchor height, push
the release button and slide the anchor down or up. Pull down on the
anchor to make sure that it is locked in place.
Always adjust the anchor height so that the shoulder belt passes over
the middle of the shoulder without touching the neck.
Seat, seatbelt and SRS airbags
HS1020BB
– CONTINUED –
1-17