Subaru 2002 Forester Owner's Manual page 183

B Manual tuning (TUNE)
n Manual tuning
Turn the tuning knob
increase the tuning frequency and turn the tuning knob counterclock-
wise and release it immediately to decrease the tuning frequency.
Each time the knob is turned, the frequency changes 10 kHz in the
AM waveband and 0.2 MHz in the FM waveband.
n Seek tuning
Turn the tuning knob
tuning will operate and stop automatically on the next station.
Continue this operation until you find the desired station.
B Automatic tuning (SCAN)
Press the "SCAN" button
this mode, the radio scans through the radio band until a station is
found. The radio will stop at the station for five seconds while display-
ing the frequency, after which scanning will continue until the entire
band has been scanned from the low end to the high end.
Press the "SCAN" button again to cancel the SCAN mode and to stop
on any displayed frequency.
When the "SCAN" button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
Automatic tuning may not function properly if the station reception is
weakened by distance from the station or proximity to tall buildings and
hills.
HS5005BA
4
clockwise and release it immediately to
4
and hold it for more than a half second. Seek
3
to change the radio to the SCAN mode. In
"" : Tuning to a higher
frequency
AA : Tuning to a lower
frequency
"" : Seeking the next
higher station
AA : Seeking the next
lower station
– CONTINUED –
Audio
5-29