Install Blower Pipes - Echo PB-770 H Operator's Manual

ASSEMBLY
5. Loosen wing nut (H). Align
notches in handle clamp with
tabs (F).
6. Slide stick handle onto swivel
pipe (C). Stick handle (E) should
be angled away from operator.
7. Position stick handle (E) over
metal plate on swivel pipe and
adjust for comfortable operation.
Tighten wing nut (H).
Note: Ground lead of stick
handle must contact metal plate on swivel pipe.
8. Assemble straight pipe (J) onto
swivel pipe (C), until you feel light
resistance. Do not force
connection. Hold swivel pipe and
turn straight pipe clockwise,
engaging positive locking
channels, until connection is
firm. Do not force connection.
9. Assemble straight pipe with
decal (K) to straight pipe (J) as in
step 8.
Note: Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If
loosening occurs, remove two straight pipes and install
according to instructions 8 & 9.
PB-770 T
Never perform maintenance or assembly procedures with
engine running or serious personal injury may result.

Install Blower Pipes

1. Assemble clamps (A) and (G)
onto both ends of flexible pipe
(B).
Note: Clamp with cable guide
loop (G) fits elbow end of
flexible pipe.
20
C
H
C
J
G
B
© 01/2020 ECHO Incorporated
PB-770 H/T
E
F
K
G
A
X7531125807