Advertisement
FIG. 7
Step 2: Two screws installed in the top frame.
The top decoration panel must be removed from the re-
frigerator before the screws can be installed.
Open the doors and remove the four screws that secure
the top decoration panel to the top frame. Two screws
are accessible from underneath see FIG. 7, the second
two screws that secure the decoration panel to the front
frame are located on each side of the lock retainer.
Carefully tilt the top decoration panel and lift up to re-
move from top frame. Be careful not to damage the cir-
cuit board and wires.
Install the two screws in the top frame, the holes are
accessible from underneath.
Seal the opening for the screws with aluminum tape.
Replace the top decoration panel with its four screws.
Be careful not to pinch the wires behind the panel.
6
STEP 3: Two screws installed in the rear base.
See FIG. 8.
FIG. 8
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and
cabinet.
Any space between the counter, storage area or ceiling
and top of the refrigerator greater den 1-1/2 inches should
be blocked. The heat produced at the rear of the refrig-
erator will become trapped in this space, making the top
of the refrigerator hot and reduce the efficiency of the
refrigerator.
Drain water hose
A hole must be drilled through flooring see FIG. 8.
The hole must be drilled in the cut out opening of the
base plate at the rear of the refrigerator. The installer
MUST make sure that the hose does not kink when run
through the floor. Seal around the hose that goes through
the drilled hole. If a longer hose than supplied is required
to get the water to drain outside of the vehicle, the in-
staller will have to supply the extra length of hose.
Hole for drain
water hose
Advertisement
