Quick Start
Set the Clock and Go
Press the Mode button.
While holding the Mode,
MODE
press the Fan button for
2 seconds to enter Setup
FAN
screens.
I
I2:00
Press both Mode and
Fan buttons as
above to return to
normal operation.
The thermostat is preprogrammed from the
factory to operate 1 or 2 Stage equipment* without
the need for further programming. To optimize the
installation of this thermostat follow the instructions
in the Advanced Setup section.
* The thermostat is not preprogrammed from the
factory to operate electric heat or heat pump systems.
To control these systems, follow the steps in the
Advanced Setup section, page 12.
Pressing the Up and Down
buttons will modify the flashing
selection.
MODE
FAN
Page 5
To adjust the
clock use
buttons.