Pontiac 2007 G6 Owner's Manual page 121

It is possible for the PASS-Key
to "learn" the transponder value of a new or
replacement key. Up to 10 additional keys may
be programmed for the vehicle. The following
procedure is for programming additional keys only.
If all the currently programmed keys are lost or
do not operate, you must see your dealer or a
locksmith who can service PASS-Key
keys made and programmed to the system.
See your dealer or a locksmith who can service
®
PASS-Key III+ to get a new key blank that is cut
exactly as the ignition key that operates the system.
To program the new key do the following:
1. Verify that the new key has
2. Insert the already programmed key in the
ignition and start the engine. If the engine
will not start, see your dealer for service.
3. After the engine has started, turn the key to
OFF, and remove the key.
®
III+ decoder
®
III+ to have
1
stamped on it.
4. Insert the key to be programmed and turn it to
the ON position within five seconds of
removing the original key.
5. The SECURITY light will turn off once the key
has been programmed.
6. Repeat Steps 1 through 5 if additional keys
are to be programmed.
If you are ever driving and the SECURITY light
comes on and stays on, you may be able to restart
your engine if you turn it off. Your PASS-Key
system, however, is not working properly and must
be serviced by your dealer. Your vehicle is not
protected by the PASS-Key
this time.
If you lose or damage your PASS-Key
see your dealer or a locksmith who can service
®
PASS-Key III+ to have a new key made.
®
III+
®
III+ system at
®
III+ key,
121