Table of Contents
Advertisement
Quick Start Guide
3.4 DS90UB95x-Q1EVM Setup
1. Use the mini USB to USB cable to connect J2 to computer USB port for register programming and open
Analog LaunchPAD. See
2. Configure jumpers J8, J10, J11, J15, J16, J23, J27 to set device's operating modes. The default
configuration can be seen in
3. Configure Power-over-Coax power supplies for RX0 and RX1 with J18 and J17 respectively.
4. Connect the DS90UB95x-Q1EVM to DS90UB953-Q1EVM (or variant) to RX0 and/or DS90UB933-Q1EVM
to RX1 using a coax cable.
5. Interface MIPI CSI-2 output signals (J24) to test equipment or host processor (optional, not required to check
status of FPD-Link III connection between serializer and deserializer).
6. Provide power to board. TI recommends using current limited bench supply to provide power to J1 (barrel
jack) or J3.
4 DS90UB95x-Q1EVM Board Configuration
4.1 Default Configuration
Default jumper placement shown in red. This configuration sets the device into the following mode
•
Device is set for FPD-Link III inputs from coax in CSI mode (for DS90UB953-Q1EVM (or variant))
•
VDDIO is set to 1.8V
•
VDD5V is powered by the 5V LDO
•
The 3.3V + 1.1V LDO (U10) is powered by VDD5V
•
The 9V LDO for PoC for RX0 and RX1 are enabled
6
DS90UB95x-Q1EVM Deserializer User's Guide
Section 12
for details on installing and using Analog LaunchPAD.
Figure
4-1.
Figure 4-1. DS90UB95x-Q1EVM with Jumpers Highlighted
Copyright © 2021 Texas Instruments Incorporated
SNLU223B – AUGUST 2017 – REVISED APRIL 2021
Submit Document Feedback
www.ti.com
Advertisement
Table of Contents
