Table of Contents
Advertisement
www.ti.com
Disable the demo mode by selecting the "Preferences" pull down menu and un-checking "Enable Demo Mode".
After demo mode is disabled, the ALP software will poll the ALP hardware. The ALP software will update and
have only "DS90UB95x" under the "Devices" pull down menu.
14.2 USB2ANY Firmware Issues
If upon plugging in the board to the PC, the user is presented with a message stating USB2ANY firmware is
out of date or is 0.0.0.0, similar to
S1 while plugging in the USB cable puts the USB2ANY into firmware update mode). If that does not solve
the problem you will have to re-flash the on-board USB2ANY firmware. To re-flash the USB2ANY, download
USB2ANY Explorer
and install the application. Launch the USB2ANY Firmware Loader available at "C:\Program
Files (x86)\TI USB2ANY SDK\bin\USB2ANY Firmware Loader.exe" and follow the instructions to flash the latest
version of USB2ANY firmware. The firmware loading screen is shown in
SNLU223B – AUGUST 2017 – REVISED APRIL 2021
Submit Document Feedback
Figure 14-3. ALP in Demo Mode
Figure 14-4. ALP Preferences Menu
Figure
14-5, try unplugging the USB cable and plugging it in again (holding
Copyright © 2021 Texas Instruments Incorporated
Troubleshooting ALP Software
Figure
14-6.
DS90UB95x-Q1EVM Deserializer User's Guide
35
Advertisement
Table of Contents
