Adjusting Blade Guides - Grizzly T32304 Owner's Manual

Lower Blade Support Bearing:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove table.
Note: Fence and meat pusher can remain
installed when removing table.
3. Loosen support bearing adjustment screw
(see Figure 35).
Support
Bearing
Figure 35. Lower blade guide support bearing
(table removed).
4.
Position support bearing approximately
away from back of blade.
5.
Tighten support bearing adjustment screw.
6. Re-install table removed in Step 2.
Model T32304 (Mfd. Since 02/21)
The upper blade guides (see Figure 36) can be
adjusted left-to-right, as well as front-to-back, rel-
ative to the blade. Properly adjusted blade guides
provide side-to-side support, from just behind the
gullets to the back of the blade, to help keep the
blade straight while cutting.
Adjustment
Adjustment
Screw
Figure 36. Upper blade guide assembly (blade
⁄ "
1
32
IMPORTANT: Verify blade is tracking and ten-
sioned correctly before performing this procedure
(see Tensioning Blade on Page 25).
Tools Needed
Hex Wrench 5mm ............................................... 1
To adjust blade guides:
1.
2.
3.
Adjusting Blade
Guides
Guide
Screws
guard removed).
DISCONNECT MACHINE FROM POWER!
Remove blade guard.
Loosen (2) guide adjustment screws (see
Figure 36), adjust blade guides approximate-
ly 0.004" (about the thickness of a dollar bill)
away from blade, and tighten screws.
Upper
Blade Guide
Assembly
Blade Guide
(1 of 2)
Qty
-27-