Final Transmission Oil - Yamaha MIO AL115S Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
_
Be sure to wipe off spilled oil on any
parts after the engine and exhaust
system have cooled down.
_
NOTICE
_
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a
higher quality than specified. In
addition, do not use oils la-
beled "ENERGY CONSERVING
II" or higher.
7
●
Make sure that no foreign ma-
terial enters the crankcase.
_
8. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the en-
gine off and check for the cause.
9. Turn the engine off, and then
check the oil level and correct it if
necessary.

Final transmission oil

ECA11620
ZAUU0057
1. Final transmission oil filler cap
The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm up the fi-
nal transmission oil by riding the
scooter for several minutes, and
then stop the engine.
2. Place the scooter on the center-
stand.
7-11
EAU20064
ZAUU0058
1. Final transmission oil drain bolt
3. Place an oil pan under the final
transmission case to collect the
used oil.
4. Remove the final transmission oil
filler cap and final transmission
drain bolt to drain the oil from the
final transmission case.
5. Install the final transmission oil
drain bolt, and then tighten it to
the specified torque.
Tightening torque:
Final transmission oil drain bolt:
22 Nm (2.2 m·kgf, 16 ft·lbf)