Table of Contents
Advertisement
Activating Distronic
You can activate Distronic if
you are driving between 25 mph
(40 km/h) and 110 mph (180 km/h)
the ESP is activated ( page 79)
If Distronic has not been activated after
pressing the cruise control lever you will
see the message
in the multifunction
---
display.
In the following cases you cannot activate
Distronic:
up to two minutes after starting the en-
gine
when you brake
if you have set the parking brake
if the gear selector lever is in
position P, R or N
if the ESP is switched off
Setting the current speed
Accelerate or decelerate to the desired
speed.
Briefly lift or depress the cruise control
lever.
Distronic is activated and the current
speed is set.
Remove your foot from the accelerator
pedal.
i
If you do not take your foot off of the
accelerator completely, the following
message will appear in the multifunc-
tion display:
DISTRONIC OVERRIDE
.
Distronic will not work to maintain the
distance to slower moving vehicles in
front of you. Your vehicle speed will
then be determined only by the accel-
erator pedal position.
Controls in detail
Driving systems
Setting a higher speed
Briefly tip the cruise control lever in the
direction of arrow 1 ( page 202) to
increase vehicle speed in increments
of 5 mph (Canada: 10 km/h).
The new speed is set.
The stored speed is displayed in the
multifunction display for approximately
five seconds ( page 202), and one or
two segments around the stored speed
come on on the speedometer
( page 200).
i
Depressing the accelerator pedal does
not deactivate Distronic. After brief ac-
celeration (e.g. for passing), the cruise
control will resume the last speed set.
203
Advertisement
Table of Contents
