Mazda 2010 CX-9 Owner's Manual page 504

CX-9_8AU2-EA-09G_Edition1 Page504
Wednesday, July 8 2009 12:11 AM
Maintenance and Care
Owner Maintenance
2. Turn the screws counterclockwise and
remove them.
3. Turn the screws and the center section
of the plastic retainers
counterclockwise and remove them,
then remove the mudguard.
Removal
Installation
4. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finger and
pulling the connector downward.
í
8-42
Some models.
Form No.8AU2-EA-09G
Black plate (504,1)
5. Turn the socket and bulb assembly
counterclockwise and remove it.
Carefully remove the bulb from its
socket in the reflector by gently pulling
it straight backward out of the socket.
6. Install the new bulb in the reverse order
of removal.
NOTE
To replace the bulb, contact an Authorized
l
Mazda Dealer
If the halogen bulb is accidentally touched,
l
it should be cleaned with rubbing alcohol
before being used.
Use the protective cover and carton of the
l
replacement bulb to dispose of the old bulb
promptly out of the reach of children.
í
Side turn signal lights
Taillights, High-mount brake light
Due to the complexity and difficulty of
the procedure, the LED bulbs should be
replaced by an Authorized Mazda Dealer.
NOTE
LED bulb replacement is not possible. The
rear combination component must be replaced.
, Brake lights,