Replacing Parking Lamp/Turn Signal Bulbs - Lincoln 1998 Navigator Owner's Manual

Maintenance and care
8. Without turning, carefully pull the
bulb assembly out of the headlamp
assembly.
9. Insert the glass end of the new
bulb into the socket. When the
grooves in the plastic base are
aligned, push the bulb into the
socket until the plastic base
contacts the rear of the socket.
10. To complete reinstallation of the
headlamp assembly, follow the removal procedures in reverse order.

Replacing parking lamp/turn signal bulbs

1. Make sure the headlamp control is in the OFF position.
2. Open the hood.
3. At the back of the headlamp,
remove the headlamp assembly
retainers by pushing rearward and
pulling up.
4. Pull the headlamp assembly
forward slightly to expose the
electrical connectors.
5. Disconnect the electrical
connector from the bulb socket.
6. Rotate the bulb socket
counterclockwise about ¼ turn and
remove.
7. Without turning, carefully pull out
the bulb.
162