Hummer 2006 H2 Owner's Manual page 89

3. Press either one of the two power midgate
release buttons. The midgate
forward from its closed position. The latch release
buttons operate while the ignition is in RUN,
ACCESSORY, in RAP mode, or up to ten minutes
after removing the key. If necessary, press the
global express-down button to reactivate the release
buttons for an additional ten minutes.
®
4. Pull the midgate inward and down to its fully
lowered position.
5. Flip the auxiliary panel on the top of the midgate
into position to bridge the gap created by the
hinges in the midgate
on the panel.
®
latch
®
will move slightly
®
. There are two finger holds
Raising the Midgate
To raise the midgate
1. Fold the auxiliary panel back into the exterior of the
®
midgate . The panel should snap loudly back into
position which means it is secure.
2. Reverse the steps for lowering the midgate
previously. The midgate
both sides before the window can be raised.
3. Press the top part of the midgate
express-up the window. To stop the window, press
the switch a second time.
®
®
®
, do the following:
®
must be fully latched on
®
window switch to
®
listed
2-13