Level 1 Programming; Modifying Product Settings - Henny Penny LVE-102 Operator's Manual

4-1. MODIFYING PRODUCT
SETTINGS
1207
SECTION 4. LEVEL 1 PROGRAMMING
Level 1 contains the following:
• Modify product settings
• Set the AIF clock for products
• Perform the Deep Clean procedure
• Fryer Setup Mode
1. Press and hold
in the display, followed by ENTER CODE.
2. Enter code 1, 2, 3, 4 (first 4 product buttons). "PRODUCT"
and "SELECTN" show in the displays.
3. Press right √ √ √ √ √ button and 'SELECT PRODUCT' and "-P 1-"
(ex: NUGGETS) show in the displays.
Change Product Names
4. Use the
or press the desired product button
5. Press right √ √ √ √ √ button and the product (ex: NUGGETS) shows in
the left display and "MODIFY", and "YES NO" shows
in the right display. Press the √ √ √ √ √ button to change this product,
or press the X button to choose another product.
6. If √ √ √ √ √ button was pressed, press and release a product button
and the flashing letter changes to the first letter under the
product button that was pressed. For example, if
pressed, the flashing letter changes to an "A".
Press the same button again and the flashing letter changes to a
"B". Press it again and the flashing letter changes to a "C".
Once the desired letter shows in the display, press
to continue to the next letter and repeat the procedure.
Press and hold the right X button to exit Program Mode, or
press
To Change Times and Temperatures
7. Press
and then use the product buttons
to change the time in minutes and seconds, to a maximum of
59:59.
and buttons until LEVEL - 1 shows
and buttons to scroll through the 40 products,
button to continue on to "1. COOK TIME".
button until "COOK TIME" shows in the display,
Model LVE-102, 103, 104
is
button
4-1