GMC 2007 Sierra 1500 Pickup Owner's Manual page 313

© ¨
SCAN : Press and hold either the SCAN or
the TYPE arrows for more than two seconds
until SCAN appears on the display and you hear a
beep. The radio will go to the next selection,
play for 10 seconds, then go on to the next
selection. Press either the SCAN or the TYPE
arrows again, to stop scanning. The tape
must have at least three seconds of silence
between each selection for scan to work.
BAND: Press this button to listen to the radio
when a cassette tape or CD is playing. The
inactive tape or CD will remain safely inside the
radio for future listening.
TAPE DISC: Press this button to play a cassette
tape or CD when listening to the radio. The
inactive tape or CD will remain safely inside the
radio for future listening.
(Eject): Press this button to stop and eject a
Z
tape when it is playing or to eject a tape when
it is not playing. Eject may be activated with
the radio off.
Cassette Tape Messages
CHK TAPE (Check Tape): If this message
appears on the display, the tape will not play due
to one of the following errors:
•
The tape is tight and the player cannot turn
the tape hubs. Remove the tape. Hold the
tape with the open end down and try to turn
the right hub counterclockwise with a
pencil. Turn the tape over and repeat. If the
hubs do not turn easily, the tape may be
damaged and should not be used in the
player. Try a new tape to make sure your
player is working properly.
•
The tape is broken. Try a new tape.
•
The tape is wrapped around the tape head.
Attempt to get the cassette out. Try a new tape.
313