Certification/Tire Label - GMC 2004 Canyon Owner's Manual

Certification/Tire Label
The Certification/Tire label is attached to the bottom
section of the center pillar, on the driver's side of
the vehicle. Vehicles without a center pillar, extended
cab models, will have the Certification/Tire label
attached to the edge of the driver's side, third door,
below the door latch post. The label shows the size of
your original tires and the inflation pressures needed
to obtain the gross weight capacity of your vehicle.
This is called the Gross Vehicle Weight Rating (GVWR).
The GVWR includes the weight of the vehicle, all
occupants, fuel, cargo and trailer tongue weight,
if pulling a trailer.
4-56
The Certification/Tire label also tells you the maximum
weights for the front and rear axles, called Gross
Axle Weight Rating (GAWR). To find out the actual loads
on your front and rear axles, you need to go to a
weigh station and weigh your vehicle. Your dealer can
help you with this. Be sure to spread out your load
equally on both sides of the centerline.
Never exceed the GVWR for your vehicle, or the GAWR
for either the front or rear axle.
If you do have a heavy load, you should spread it out.
Similar appearing vehicles may have different GVWRs
and payloads. Please note your vehicle's Certification/
Tire label or consult your dealer for additional details.
CAUTION:
{
Do not load your vehicle any heavier than the
GVWR, or either the maximum front or rear
GAWR. If you do, parts on your vehicle can
break, and it can change the way your vehicle
handles. These could cause you to lose
control and crash. Also, overloading can
shorten the life of your vehicle.