GMC 1996 Sonoma Owner's Manual page 262

Taillamps
4. Install a new bulb.
5. Replace the lens. Install and tighten the screws.
If equipment such as a cap or camper is installed on
your vehicle, a center high-mounted stoplamp feed wire
is provided along the driver's side rear frame. This wire
should be used
t o
install
a
center high-nlounted
stoplamp in the cap
01-
camper.
1 . Open
the tailgate.
2. Remove the screws from
the lamp assembly near
the tailgate latch.
3. Pull the assembly away from the pickup side panel.
L C . Turn the socket counterclockwise to remove it. Push
the tab i n while you turn the socket.
5. Pull the bulb out.
6. Push the new bulb into the socket.
7. Put
the socket into the ussCmbly and turn the socket
clockwise
until it
locks i n place.
8. Replace the assembly. Install and tighten the screws.
9. Close
the tailgate.