Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer - Chevrolet 2008 Colorado Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will automatically
return to the off position.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until the change is
completed. The lever will return by itself when released.
As you signal a turn or a lane change, if the arrows
flash more quickly than normal, a signal bulb may
be burned out and other drivers will not see your
vehicle's turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when signaling
a turn, check for a burned-out bulb or a blown fuse.
3-8
An arrow on the instrument
panel cluster will flash
in the direction of the
turn or lane change.
For bulb replacement, see Taillamps, Turn Signal,
Stoplamps and Back-up Lamps on page 5-54. For a
blown fuse or circuit breaker, see Fuses and Circuit
Breakers on page 5-116
Turn Signal On Chime
If a turn signal is left on for more than 3/4 of a mile
(1.2 km), a chime will sound at each flash of the turn
signal and the message TURN SIGNAL will also appear
in the DIC. To turn the chime and message off, move
the turn signal lever to the off position.
See "TURN SIGNAL" under DIC Warnings and
Messages on page 3-42 for more information.

Headlamp High/Low-Beam Changer

53 (Headlamp High/Low Beam Changer): To
change the headlamps from low to high beam, push the
lever toward the instrument panel. To return to low-beam
headlamps, pull the multifunction lever toward you. Then
release it.
When the high beams are
on, this indicator light on
the instrument panel
cluster will also be on.