Table of Contents
Advertisement
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block mode (most
new drives do), select Enabled for automatic detection of the optimal number
of block read/writes per sector the drive can support. The settings are:
Enabled, Disabled.
Power On Function
This function allows you to select the item to power on the system.
The settings are : Any Key, Button Only, Mouse Left, Mouse Right,
Password, Hotkey, keyboard 98.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD)
installed on the system board and you wish to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and
second serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
UART Mode Select
This item allows you to determine which InfraRed(IR) function of the
onboard I/O chip, this functions uses.
3-17
®
Advertisement
Table of Contents
