Chevrolet 2007 Avalanche Owner's Manual page 516

When rotating your vehicle's tires, always use the
correct rotation pattern shown here.
Do not include the spare tire in the tire rotation.
After the tires have been rotated, adjust the
front and rear inflation pressures as shown on the
tire and loading information label. See Loading
Your Vehicle on page 409 and Inflation - Tire
Pressure on page 509, for more information.
Vehicles that have the Tire Pressure Monitor
System (TPMS) will need to have the TPMS
sensors reset after a tire rotation. See "TPMS
Sensor Identification Codes" under Tire Pressure
Monitor System on page 510.
516
Make certain that all wheel nuts are properly
tightened. See "Wheel Nut Torque" under
Capacities and Specifications on page 566.
CAUTION:
{
Rust or dirt on a wheel, or on the parts to
which it is fastened, can make wheel nuts
become loose after a time. The wheel
could come off and cause an accident.
When you change a wheel, remove any
rust or dirt from places where the wheel
attaches to the vehicle. In an emergency,
you can use a cloth or a paper towel to do
this; but be sure to use a scraper or wire
brush later, if needed, to get all the rust
or dirt off. See Changing a Flat Tire on
page 526.