Battery Voltage Too Low; Check Oil Level; Cargo Cover Ajar; Driver Door Ajar - Chevrolet 2005 SSR Pickup Owner's Manual

Battery Voltage Too Low

This message will be displayed when the battery
voltage is lower than normal and you try to raise or
lower the convertible top. The charging system light
may also be displayed on the instrument panel cluster.
See Charging System Light on page 3-29 for more
information. Press the select button to acknowledge the
message and clear it from the DIC display.

Cargo Cover Ajar

This message will be displayed when trying to open
or close the convertible top while the cargo cover
is open. Make sure the cargo cover is fully closed
before trying to open or close the convertible top.
This message will clear itself from the DIC once the
cargo cover is closed.
Change Trans (Transmission) Fluid
(Automatic Transmission Only)
If your transmission fluid in your vehicle needs to
be changed, this message will appear on the DIC.
See Automatic Transmission Fluid on page 5-21 and
Scheduled Maintenance on page 6-4 for more
information.
3-46

Check Oil Level

If the oil level in the vehicle is low, this message will
appear on the DIC. Check the oil level and add oil
as necessary. See Engine Oil on page 5-13 for more
information. Press the select button to acknowledge this
message and clear it from the DIC display.
Depress Brake
This message will be displayed on the DIC when you
try to raise or lower the convertible top without first
pressing the brake pedal. The brake pedal must
be pressed in order to operate the convertible top.
See Convertible Top on page 2-51 for more information.
Pressing the brake pedal will clear the message, or
you can press the select button to acknowledge
and clear the message from the DIC display.

Driver Door Ajar

This message will be displayed on the DIC and a
chime will sound when the driver's door is not closed
completely. Stop the vehicle, check the door for
obstacles, and close the door again. Fully closing the
driver's door will clear this message from the display,
or you can press the select button to acknowledge
the message and clear it from the DIC display.