22 7/32" Allen Wrench - Life Fitness LF-ARC-LB-B1 Assembly Instructions Manual

Tools Required
• Phillips screwdriver
• Stubby Phillips screwdriver
• 6 mm Allen wrench
Lift and Move Unit
1. Remove lag bolts and shipping supports. Keep package material on linkage arms at this time. This will protect the
paint from scratching during assembly.
2. Grasp each rear support leg firmly and lift with one person on each side.
3. Lift the lower rear support legs so the front transport wheels are able to roll on floor.
Use proper lifting methods.
4. Move unit to intended location.
5. Lower rear support legs.
Install Console Weldment
1. Remove the locknuts and washers from the bolts securing the console weldment to the frame using two 9/16"
open-end wrenches.
NOTE: Single box option with console pre-assembled shown.
2. While holding the console weldment, remove the two bolts and washers from the frame. Discard the bolts,
washers, and locknuts, these are only used for shipping.
3. Place console weldment into position on frame.
4. Insert (from underneath) four bolts and lower bracket into frame and console weldment.
5. Thread four locknuts onto bolts by hand.
6. Tighten four bolts and locknuts with a 7/32" Allen wrench and a 9/16" open-end wrench.
• 7 mm Allen wrench
• 7/32" Allen wrench
• 17 mm Open end wrench
Item
Page 15 of 45
• 1/2" Open end wrench
• 9/16" Open end wrench
Item Description
1 Console assembly
2 Bolts
3 Washers
4 Frame
5 Locknuts
Description
1 Weldment, Console
2 Frame
3 Bracket, Lower
4 Screw, Socket Head, .375-16 x 2.5"
5 Locknut, 375-16 Nylon
Qty
1
2
2
1
2
Qty
1
1
1
4
4